|国家预印本平台
首页|基于电流前馈控制的单周期Boost APFC

基于电流前馈控制的单周期Boost APFC

One cycle Boost APFC based on current feedforward control

中文摘要英文摘要

单周期控制具有鲁棒性好、结构简单等优点,因此在功率因数校正方面获得了广泛应用。这种结构具有很好的抗输入电压扰动能力,但是缺点是负载动态响应相对缓慢。因此采用了负载电流前馈控制,来提高单周期控制的Boost APFC的负载瞬态响应。但是负载电流前馈的引入会增加变换器的二次纹波,使电路的电流畸变增大,降低电路的功率因数。因此本文采用含有两倍输出电压频率陷波滤波器的负载电流前馈,分析不同品质因数对调制电压的影响。最后,对其建模和仿真,仿真结果表明该方法能够在不增加二次纹波的同时,显著提高负载动态响应。

One cycle control has the advantages of good robustness and simple structure, so it has been widely used in power factor correction. The structure has good ability to resist input voltage disturbance, but the dynamic response of load is relatively slow. Therefore, the load current feed-forward control is adopted to improve the transient response of the Boost APFC with one cycle control. However, the introduction of load current feed-forward will increase the two ripple of converter, increase the current distortion of the circuit, and reduce the power factor of the circuit. Therefore, the load current feedforward with two times output voltage frequency notch filter is adopted in this paper, and the influence of different quality factor on modulation voltage is analyzed. Finally, the simulation and simulation results show that the proposed method can significantly improve the dynamic response of the load without adding two ripple.

冯林凯、宋桂英

变压器、变流器、电抗器

功率因数校正电流前馈控制负载动态响应二次纹波

power factor correctioncurrent feed-forward controlload dynamic responsesecond harmonic

冯林凯,宋桂英.基于电流前馈控制的单周期Boost APFC[EB/OL].(2017-07-12)[2025-08-21].http://www.paper.edu.cn/releasepaper/content/201707-41.点此复制

评论