(Ca,Sr)3Al2O6:Ce3+荧光粉的合成与发光性质研究
Synthesis and Luminescent Properties of (Ca,Sr)3Al2O6:Ce3+ Phosphor
本章采用高温固相法合成了一系列具有不同Ca/Sr比的Ca3-xSrxAl2O6:Ce3+荧光粉,通过对其物相、光致激发和发射光谱、荧光寿命等性质的研究。随着Sr2+的量的逐渐增加,样品的XRD衍射峰逐渐向低角度移动,但峰形保持不变,说明Sr2+的引入在不改晶体类型的情况下晶胞变大了。在305 nm激发下,荧光粉的发射主峰均位于约470 nm处,且强度随着Sr2+含量的增加而逐渐减弱;而在365 nm激发下,荧光粉的发射波长随着Sr2+的增多从~420 nm增大到~470 nm,且当Sr2+的量(x)为0.5时,强度最大。且随着Sr的存在,出现了398 nm处的新激发带,对应的发射峰也红移到月500 nm处。文章对发光性质与Ce3+所处格位进行了分析。
In this paper, a series of Ca3-xSr3Al2O6:Ce3+ phosphors were synthesized by a tranditional solid-state reaction and the corresponding structure, photoluminescent excitation and emission spectra were studied. The diffraction peaks of the XRD patterns shift to low angles with the increase of Sr2+ content, while the profile of peaks stays unchanges, which implies that the introduction of Sr2+ results in the increase of unit cell without the change of crystal structure. Phosphors exhibit an emission (PL) band peaking at 470 nm under excitation at 305 nm, and the corresponding PL intensity decrease with the increase of Sr2+ content. On the other hand, when excited at 365 nm, the PL band shifts from ~420 nm to ~470 nm with the increase of Sr2+ content, which has a highest intensity when Sr2+ content (x) is 0.5. Furthermore, an additional excitation band appears when Sr2+ exists, and the related PL band is at 500 nm. The relationship between luminescent properties and crystallographic site for Ce3+ ions are studied in detail.
李梦乔、张吉林、廉世勋
化学晶体学
其他功能无机非金属材料荧光粉e3+光谱调控
inorganic functional nonmetallic materialsphosphorCe3+spectral adjustment
李梦乔,张吉林,廉世勋.(Ca,Sr)3Al2O6:Ce3+荧光粉的合成与发光性质研究[EB/OL].(2017-04-28)[2025-08-16].http://www.paper.edu.cn/releasepaper/content/201704-790.点此复制
评论