基于MPC 延时补偿器的农机多机器人编队行驶轨迹跟踪方法

Objective]The technology of multi-machine convoy driving has emerged as a focal point in the field of agricultural mechanization. By organizing multiple agricultural machinery units into convoys, unified control and collaborative operations can be achieved. This not only enhances operational efficiency and reduces costs, but also minimizes human labor input, thereby maximizing the operational potential of agricultural machinery. In order to solve the problem of communication delay in cooperative control of multi-vehicle formation and its compensation strategy, the trajectory control method of multi-vehicle formation was proposed based on model predictive control (MPC) delay compensator. [Methods]The multi-vehicle formation cooperative control strategy was designed, which introduced the four-vehicle formation cooperative scenario in three lanes, and then introduced the design of the multi-vehicle formation cooperative control architecture, which was respectively enough to establish the kinematics and dynamics model and equations of the agricultural machine model, and laied down a sturdy foundation for solving the formation following problem later. The testing and optimization of automatic driving algorithms based on real vehicles need to invest too much time and economic costs, and were subject to the difficulties of laws and regulations, scene reproduction and safety, etc. Simulation platform testing could effectively solve the above question. For the agricultural automatic driving multi-machine formation scenarios, the joint simulation platform Carsim and Simulink were used to simulate and validate the formation driving control of agricultural machines. Based on the single-machine dynamics model of the agricultural machine, a delay compensation controller based on MPC was designed. Feedback correction first detected the actual output of the object and then corrected the model-based predicted output with the actual output and performed a new optimization. Based on the above model, the nonlinear system of kinematics and dynamics was linearized and discretized in order to ensure the real-time solution. The objective function was designed so that the agricultural machine tracks on the desired trajectory as much as possible. And because the operation range of the actuator was limited, the control increment and control volume were designed with corresponding constraints. Finally, the control increment constraints were solved based on the front wheel angle constraints, front wheel angle increments, and control volume constraints of the agricultural machine. [Results and Discussions]Carsim and MATLAB/Simulink could be effectively compatible, enabling joint simulation of software with external solvers. When the delay step size d=5 was applied with delay compensation, the MPC response was faster and smoother; the speed error curve responded faster and gradually stabilized to zero error without oscillations. Vehicle 1 effectively changed lanes in a short time and maintains the same lane as the lead vehicle. In the case of a longer delay step size d =10, controllers without delay compensation showed more significant performance degradation. Even under higher delay conditions, MPC with delay compensation applied could still quickly respond with speed error and longitudinal acceleration gradually stabilizing to zero error, avoiding oscillations. The trajectory of Vehicle 1 indicated that the effectiveness of the delay compensation mechanism decreased under extreme delay conditions. The simulation results validated the effectiveness of the proposed formation control algorithm, ensuring that multiple vehicles could successfully change lanes to form queues while maintaining specific distances and speeds. Furthermore, the communication delay compensation control algorithm enables vehicles with added delay to effectively complete formation tasks, achieving stable longitudinal and lateral control. This confirmed the feasibility of the model predictive controller with delay compensation proposed. [Conclusions]At present, most of the multi-machine formation coordination is based on simulation platform for verification, which has the advantages of safety, economy, speed and other aspects, however, theres still a certain gap between the idealized model in the simulation platform and the real machine experiment. Therefore, multi-machine formation operation of agricultural equipment still needs to be tested on real machines under sound laws and regulations.